Summary: | The Yukon River Sonar Project estimates salmon passage through the river near Pilot Station, Alaska. The hydroacoustic data collected by the sonar is currently printed on paper charts in a series of grey marks called “traces.” Technicians count traces that were generated by fish, and these numbers are used to calculate daily abundance estimates. New technology allows the hydroacoustic data to be presented on electronic charts viewed on a computer. The electronic charts also present the data in a series of grey marks, and fish traces must be identified manually by technicians. However, the electronic charts present the data in greater detail, and settings that are used to optimize the visibility of fish traces are more easily adjusted. Both of these features may improve fish detection, which would result in more accurate estimates. Project leaders are planning to make a complete switchover from paper to electronic charts. The principle aim of this study was to compare the fish counts produced by the paper and electronic formats in order to expose any biases and explain why they occur. Due to variation in the slope of the river bottom, the area of river covered by the sonar is divided into several horizontal strata by distance from the transducer. Due to the properties of sound and the variation in the shape of fish traces at different ranges, it is possible that the level and direction of bias may differ among strata. A sample of 150 electronic files, out of approximately 1,700, from the 2008 season was selected for this comparison. Files were counted using Echotastic, a program written by AYK Regional Sonar Biologist, Carl Pfisterer. The electronic chart counts were higher than the paper chart counts for strata one through four, while the electronic counts were lower than the paper counts for stratum five (linear regression output: stratum one: slope=1.112, y-intercept=44.662, stratum two: slope=1.344, y-intercept=13.615, stratum three: slope=1.098, y-intercept=-7.052, stratum four: slope=1.077, ...
|