Experimental results on improved JARE deep ice core drill-Experiments in Rikubetsu, Hokkaido in 2002 -

Deep ice coring to bedrock (3028m in depth) at Dome Fuji Station is planned during three successive summer seasons starting from 2003/2004. An improved JARE deep ice core drill (12.2m in length and 3.8m in maximum core length) was developed in December 2001 for the ice coring at Dome Fuji. In Januar...

Full description

Bibliographic Details
Main Authors: Takao Kameda, Yoshiyuki Fujii, Akiyoshi Takahashi, Yoichi Tanaka, Hideki Narita, Kunio Shinbori, Nobuhiko Azuma, Teruo Furukawa, Takayasu Yoshimoto, Morihiro Miyahara, Makato Igarashi, Mika Kohno, Sumito Matoba, Yoko Toyama, Kazuhide Satow, Shuhei Takahashi, Okitsugu Watanabe
Format: Article in Journal/Newspaper
Language:English
Published: National Institute of Polar Research 2002
Subjects:
geo
envir
Dome Fuji
Dome Fuji Station
ice core
Online Access:https://doi.org/10.15094/00009230
https://doaj.org/article/0e5f423445cf4266ae95b8c70f080f82
Description
Summary:Deep ice coring to bedrock (3028m in depth) at Dome Fuji Station is planned during three successive summer seasons starting from 2003/2004. An improved JARE deep ice core drill (12.2m in length and 3.8m in maximum core length) was developed in December 2001 for the ice coring at Dome Fuji. In January/February of 2002,we performed experiments on drill performance using artificial ice blocks in Rikubetsu, Hokkaido. In this paper, we outline the experiment and report the results. It was found through the experiment that an ice core of 3.8m length was smoothly obtained by the improved drill with three screws in the chip chamber and cutting pitch of 5mm/cycle. About 45000 small holes 1.2mm in diameter were made on the surface of the chip chamber. These small holes enabled liquid to circulate between cutters and outside of the drill through the chip chamber in the drill. The dry density of the chips was 440 to 500kg/m^3 and the chip recovery rate during ice coring was 65 to 91%. A check valve installed at the bottom of the chip chamber to prevent outflow of chips from the drill was not tested enough, but more durability is needed for the valve. The newly developed motor system and core catchers of the drill worked perfectly. The average coring speed was 24.5cm/min with cutting pitch of 5mm/cycle. The average power consumption during ice coring was 171W.

Similar Items