Impurities and current efficiency in aluminum electrolysis

This doctoral work has been performed at the Department of Material Science and Engineering, NTNU, Norway and Department of Science and Engineering Reykjavik University, Iceland. This is an experimental project run as a collaboration between Alcoa Fjarðaál, HRV engineering, Reykjavik University and...

Full description

Bibliographic Details
Main Author: Meirbekova, Rauan
Other Authors: Guðrún Arnbjörg Sævarsdóttir, Geir Martin Haarberg, Tækni- og verkfræðideild (HR), School of Science and Engineering (RU), Háskólinn í Reykjavík, Reykjavik University
Format: Doctoral or Postdoctoral Thesis
Language:English
Published: 2016
Subjects:
Online Access:https://hdl.handle.net/20.500.11815/1190
Description
Summary:This doctoral work has been performed at the Department of Material Science and Engineering, NTNU, Norway and Department of Science and Engineering Reykjavik University, Iceland. This is an experimental project run as a collaboration between Alcoa Fjarðaál, HRV engineering, Reykjavik University and the Norwegian University of Science and Technology. Current efficiency loss in aluminum electrolysis happens due to a variety of factors. One such factor is the presence of impurities. Concerns about impurities have been voiced since the quality of raw materials has declined and dry-scrubbers were installed. The most talked about impurity with detrimental effects on aluminum electrolysis is phosphorus, which can reduce current efficiency by about 1% per each 100 ppm of added phosphorus. The growing trend towards high amperage in aluminum reduction cells may require higher current densities. Therefore, it is of interest to industry to know if the phosphorus effect persists at high current densities. The main purpose of the thesis was to study the impact of phosphorus under high current density conditions (1.5 A/cm2) by adding AlPO4 into the electrolyte. Low current density (0.8 A/cm2) experiments were performed as a control. This study also included experiments at low concentrations of phosphorus (0-220 ppm), which are of particular interest for the industry. The effect of current density on current efficiency up to high current densities was also investigated prior to the experiments with impurities. Additionally, a data analysis campaign was run on operational data from Alcoa Fjarðaál. Daily measurements and operational data (from January 2011 to December 2013 at Alcoa Fjarðaál) were collected and analyzed to improve the understanding of effects of various process parameters (bath height, temperature, superheat, and age) on the concentration of phosphorus in the metal. A second objective of the thesis was to investigate the effect of sulfur in the bath on current efficiency. This was achieved by adding Na2SO4 ...