2D optimization of a Small Horizontal Axis Wind Turbine blade using flow control techniques
Abstract In this work, the optimization of the efficiency of a small horizontal axis wind turbine (SHWT) blade segment is presented. Typically, SHWTs have a radius of 1.5 to 3.5 m and a hub height of around 15 m from the ground. SHWTs operate in a relatively small Reynolds numbers range (up to 1.5x1...
Published in: | IOP Conference Series: Materials Science and Engineering |
---|---|
Main Authors: | , , , , |
Format: | Article in Journal/Newspaper |
Language: | unknown |
Published: |
IOP Publishing
2021
|
Subjects: | |
Online Access: | http://dx.doi.org/10.1088/1757-899x/1024/1/012041 https://iopscience.iop.org/article/10.1088/1757-899X/1024/1/012041 https://iopscience.iop.org/article/10.1088/1757-899X/1024/1/012041/pdf |
Summary: | Abstract In this work, the optimization of the efficiency of a small horizontal axis wind turbine (SHWT) blade segment is presented. Typically, SHWTs have a radius of 1.5 to 3.5 m and a hub height of around 15 m from the ground. SHWTs operate in a relatively small Reynolds numbers range (up to 1.5x10 6 ) and are installed inside the atmospheric boundary layer. This operational environment is characterised by volatile air flow, making the flow over the blade prone to separation. In order to counter this flow behavior, a set of flow control techniques is introduced and studied. These techniques control the flow, either passively, solely by the inclusion of blade add-ons, or actively, by adding energy to the boundary layer. More specifically, two passive flow control techniques and one active flow control technique are modelled and tested on a wind turbine blade segment. The passive techniques implemented in this study are based on the use of vortex generators and tubercles. Vortex generators are small vanes attached vertically to the lifting surface and are widely used in aerospace applications with varying degrees of success. Tubercles, which is a novel flow control technique, are sinusoidal modifications of the blade’s leading edge. The original concept has been inspired from the characteristic flipper of the humpback whale (Megaptera Novaeangliae). Regarding the active flow control technique, a dielectric barrier discharge (DBD) plasma actuator (PA) is used, a technique that adds momentum on the local flow, close to the blade’s surface, by ionizing the air. The impact on the blade aerodynamic efficiency for each technique are evaluated and presented. The results from this evaluation show that flow control techniques can offer a considerable benefit to SHWT by improving the blade’s aerodynamic characteristics, i.e. by increasing the blade lift-to-drag ratio and thus, improving their critical performance efficiency factor. |
---|