Can collected hygrothermal data illustrate observed thermal problems of the façade? – A case study from Greenland
Abstract Buildings are more vulnerable to faults in design and construction, when exposed to the extreme Greenlandic climate, however, most new materials and designs have not been tested for Arctic conditions. Thus even minor errors can result in failures like mould growth, discomfort, and unnecessa...
| Published in: | Journal of Physics: Conference Series |
|---|---|
| Main Authors: | , , |
| Format: | Article in Journal/Newspaper |
| Language: | unknown |
| Published: |
IOP Publishing
2021
|
| Subjects: | |
| Online Access: | http://dx.doi.org/10.1088/1742-6596/2069/1/012071 https://iopscience.iop.org/article/10.1088/1742-6596/2069/1/012071 https://iopscience.iop.org/article/10.1088/1742-6596/2069/1/012071/pdf |
| Summary: | Abstract Buildings are more vulnerable to faults in design and construction, when exposed to the extreme Greenlandic climate, however, most new materials and designs have not been tested for Arctic conditions. Thus even minor errors can result in failures like mould growth, discomfort, and unnecessary heat loss. Rekognizing the source of the error can be difficult, yet valuable. But how can it be identified whether the error lies in the design or quality of workmanship? This paper describes a case study from Nuuk, Greenland, where a new mineral wool insulation system was implemented. Residents were complaining about draft and cold areas. An investigation revealed that inaccurate use of the system caused several problems. Simulations of the exterior wall performance were conducted and compared to measurements. This paper discusses whether these measurements and simulations support the identified issues, and therefore if this kind of general surveillance of exterior walls can be used to determine the total performance of an exterior wall. The paper concludes that the collected data can support the issues of the complaints, and that the fundamental reasons for the problems are the design, the precision of the casted concrete and the lack of a wind barrier protecting the insulation. |
|---|