A Long-Term Geothermal Observatory Across Subseafloor Gas Hydrates, IODP Hole U1364A, Cascadia Accretionary Prism

• Published in: Frontiers in Earth Science
• Main Authors: Becker, Keir, Davis, Earl E., Heesemann, Martin, Collins, John A., McGuire, Jeffrey J.
• Other Authors: National Science Foundation, W. M. Keck Foundation
• Format: Article in Journal/Newspaper
• Language: unknown
• Published: Frontiers Media SA 2020
• Subjects: General Earth and Planetary Sciences; Canada; Methane hydrate
• Online Access: http://dx.doi.org/10.3389/feart.2020.568566; https://www.frontiersin.org/articles/10.3389/feart.2020.568566/full

We report 4 years of temperature profiles collected from May 2014 to May 2018 in Integrated Ocean Drilling Program Hole U1364A in the frontal accretionary prism of the Cascadia subduction zone. The temperature data extend to depths of nearly 300 m below seafloor (mbsf), spanning the gas hydrate stability zone at the location and a clear bottom-simulating reflector (BSR) at ∼230 mbsf. When the hole was drilled in 2010, a pressure-monitoring Advanced CORK (ACORK) observatory was installed, sealed at the bottom by a bridge plug and cement below 302 mbsf. In May 2014, a temperature profile was collected by lowering a probe down the hole from the ROV ROPOS. From July 2016 through May 2018, temperature data were collected during a nearly two-year deployment of a 24-thermistor cable installed to 268 m below seafloor (mbsf). The cable and a seismic-tilt instrument package also deployed in 2016 were connected to the Ocean Networks Canada (ONC) NEPTUNE cabled observatory in June of 2017, after which the thermistor temperatures were logged by Ocean Networks Canada at one-minute intervals until failure of the main ethernet switch in the integrated seafloor control unit in May 2018. The thermistor array had been designed with concentrated vertical spacing around the bottom-simulating reflector and two pressure-monitoring screens at 203 and 244 mbsf, with wider thermistor spacing elsewhere to document the geothermal state up to seafloor. The 4 years of data show a generally linear temperature gradient of 0.055°C/m consistent with a heat flux of 61–64 mW/m 2 . The data show no indications of thermal transients. A slight departure from a linear gradient provides an approximate limit of ∼10 −10 m/s for any possible slow upward advection of pore fluids. In-situ temperatures are ∼15.8°C at the BSR position, consistent with methane hydrate stability at that depth and pressure.