Numerical analysis for permafrost temperature field in the short term of permafrost subgrade filling
Purpose It is of great significance to study the influence of subgrade filling on permafrost temperature field in permafrost area for the smooth construction and safe operation of railway. Design/methodology/approach The paper builds up the model for the hydrothermal coupling calculation of permafro...
| Published in: | Railway Sciences |
|---|---|
| Main Authors: | , |
| Format: | Article in Journal/Newspaper |
| Language: | English |
| Published: |
Emerald
2023
|
| Subjects: | |
| Online Access: | http://dx.doi.org/10.1108/rs-04-2023-0016 https://www.emerald.com/insight/content/doi/10.1108/RS-04-2023-0016/full/xml https://www.emerald.com/insight/content/doi/10.1108/RS-04-2023-0016/full/html |
| Summary: | Purpose It is of great significance to study the influence of subgrade filling on permafrost temperature field in permafrost area for the smooth construction and safe operation of railway. Design/methodology/approach The paper builds up the model for the hydrothermal coupling calculation of permafrost using finite element software COMSOL to study how permafrost temperature field changes in the short term after subgrade filling, on which basis it proposes the method of calculation for the concave distortion of freezing front in the subgrade-covered area. Findings The results show that the freezing front below the subgrade center sinks due to the thermal effect of subgrade filling, which will trigger hydrothermal erosion in case of sufficient moisture inflows, leading to the thawing settlement or the cracking of the subgrade, etc. The heat output of soil will be hindered the most in case of July filling, in which case the sinking and the distortion of the freezing front is found to be the most severe, which the recovery of the permafrost temperature field, the slowest, constituting the most unfavorable working condition. The concave distortion of the freezing front in the subgrade area increases with the increase in temperature difference between the filler and ground surface, the subgrade height, the subgrade width and the volumetric thermal capacity of filler, while decreases with the increase of the thermal conductivity of filler. Therefore, the filler chose for engineering project shall be of small volumetric thermal capacity, low initial temperature and high thermal conductivity whenever possible. Originality/value The concave distortion of the freezing front under different working conditions at different times after filling can be calculated using the method proposed. |
|---|