Ice tilt time-series from sensors installed in boreholes drilled into Khumbu Glacier, Nepal, in 2017 and 2018 as part of EverDrill research project

• Main Authors: Hubbard, Bryn, Miles, Katie, Doyle, Samuel, Quincey, Duncan, Miles, Evan
• Format: Dataset
• Language: English
• Published: UK Polar Data Centre, Natural Environment Research Council, UK Research & Innovation 2019
• Subjects: "EARTH SCIENCE","CRYOSPHERE","GLACIERS/ICE SHEETS","GLACIERS"; "EARTH SCIENCE","TERRESTRIAL HYDROSPHERE","GLACIERS/ICE SHEETS","GLACIER MOTION/ICE SHEET MOTION"; "EARTH SCIENCE","CRYOSPHERE","SNOW/ICE","ICE MOTION"; Doyle; Ice Sheet
• Online Access: https://dx.doi.org/10.5285/1846aa2c-7617-4daf-9928-60a336e256a6; https://data.bas.ac.uk/full-record.php?id=GB/NERC/BAS/PDC/01128

The datasets are ice tilt time series from strings of accelerometers, each located at a discrete depth within one of three boreholes into Khumbu Glacier, Nepal. Ice deformation can be derived from this tilt data, but has not yet been calculated. Boreholes were drilled in May 2017 and 2018 to investigate the internal properties of Khumbu Glacier, specifically ice thickness, temperature, deformation and structure, as part of the NERC-funded 'EverDrill' research project. Supporting borehole information is provided as a related dataset. Funding was provided by the NERC grant NE/P00265X/1 and NE/P002021/1. : The datasets are ice deformation time series recorded by accelerometers mounted on strings installed into three boreholes drilled into Khumbu Glacier, Nepal. For borehole information, see Instrumented Borehole Info. : Borehole tilt and ice deformation sensors installed in 2017 were three-axis analog micromechanical system accelerometers (model MMA7361), controlled by Campbell Scientific CR1000 data loggers from the glacier surface. The sensors were installed so that the z axis recorded approximately 1 g when hanging vertically in the borehole. The digital sensors installed in 2018 are three-axis accelerometer/three-axes gyroscopes (model MPU6050), and also contain thermistors to measure temperature (model DS18B20), all controlled by a RS-485 data logger. Roll and pitch read values of 0 when the sensor is perfectly vertical hanging in the borehole. : Detailed methodology, including accuracy estimation, is presented by Doyle et al. (2018). The accelerometers installed in 2017 have an accuracy of 800 mV g-1 stated by the manufacturer (where g is the normalised gravity vector). A further calibration was carried out (details in Doyle et al. (2018)), resulting in the absolute accuracy of the tilt sensors being determined to be less than +/- 1 degree. The digital sensors installed in 2018 also measured temperature, however, these were not calibrated and are therefore only accurate to +/- 0.5 degrees Celsius.