Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior
Abstract Biodegradable cyclic acetal‐based porous scaffolds without acidic by‐products upon hydrolytic degradation are very promising in tissue engineering. However, most cyclic acetal based crosslinked polymer networks mainly utilized (meth) acrylates as reactive moieties for crosslinking. Developm...
Published in: | Polymers for Advanced Technologies |
---|---|
Main Authors: | , , , , , |
Format: | Article in Journal/Newspaper |
Language: | English |
Published: |
Wiley
2021
|
Subjects: | |
Online Access: | http://dx.doi.org/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/pdf/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/full-xml/10.1002/pat.5217 |
id |
crwiley:10.1002/pat.5217 |
---|---|
record_format |
openpolar |
spelling |
crwiley:10.1002/pat.5217 2024-06-02T08:05:12+00:00 Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior Wang, Kemin Kang, Liangfa Lu, Yuhui Zhu, Qifan Jiang, Shan Yin, Ruixue 2021 http://dx.doi.org/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/pdf/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/full-xml/10.1002/pat.5217 en eng Wiley http://onlinelibrary.wiley.com/termsAndConditions#vor Polymers for Advanced Technologies volume 32, issue 5, page 1997-2006 ISSN 1042-7147 1099-1581 journal-article 2021 crwiley https://doi.org/10.1002/pat.5217 2024-05-03T11:53:16Z Abstract Biodegradable cyclic acetal‐based porous scaffolds without acidic by‐products upon hydrolytic degradation are very promising in tissue engineering. However, most cyclic acetal based crosslinked polymer networks mainly utilized (meth) acrylates as reactive moieties for crosslinking. Development of cyclic acetal based crosslinked polymer networks without (meth) acrylate terminal groups and fabrication of cyclic acetal based high‐porous scaffolds are still challenging. In this study, a novel cyclic acetal monomer with carbonic acid allyl ester terminal groups was synthesized and a series of high‐porous scaffolds with tunable swelling ability and degradation rate were fabricated by thiol‐ene photopolymerization combined with low‐temperature phase‐separation method. The obtained scaffolds exhibited high porosity of 78%–89%. The average pore size and porosity of porous scaffolds increased with the increase of solvent content during scaffold fabrication. The introduction of PEG chains into scaffolds had a slight influence on the pore size, but can significantly enhance the swelling ability and hydrolytic degradation rate of resulted scaffolds. MTT assay and cell adhesion experiments indicated that the scaffolds are non‐toxic toward L929 cells and had good in vitro biocompatibility. The proposed cyclic acetal based high porous scaffolds with tunable hydrophilicity and degradation behavior have great potential in tissue engineering application. Article in Journal/Newspaper Carbonic acid Wiley Online Library Polymers for Advanced Technologies 32 5 1997 2006 |
institution |
Open Polar |
collection |
Wiley Online Library |
op_collection_id |
crwiley |
language |
English |
description |
Abstract Biodegradable cyclic acetal‐based porous scaffolds without acidic by‐products upon hydrolytic degradation are very promising in tissue engineering. However, most cyclic acetal based crosslinked polymer networks mainly utilized (meth) acrylates as reactive moieties for crosslinking. Development of cyclic acetal based crosslinked polymer networks without (meth) acrylate terminal groups and fabrication of cyclic acetal based high‐porous scaffolds are still challenging. In this study, a novel cyclic acetal monomer with carbonic acid allyl ester terminal groups was synthesized and a series of high‐porous scaffolds with tunable swelling ability and degradation rate were fabricated by thiol‐ene photopolymerization combined with low‐temperature phase‐separation method. The obtained scaffolds exhibited high porosity of 78%–89%. The average pore size and porosity of porous scaffolds increased with the increase of solvent content during scaffold fabrication. The introduction of PEG chains into scaffolds had a slight influence on the pore size, but can significantly enhance the swelling ability and hydrolytic degradation rate of resulted scaffolds. MTT assay and cell adhesion experiments indicated that the scaffolds are non‐toxic toward L929 cells and had good in vitro biocompatibility. The proposed cyclic acetal based high porous scaffolds with tunable hydrophilicity and degradation behavior have great potential in tissue engineering application. |
format |
Article in Journal/Newspaper |
author |
Wang, Kemin Kang, Liangfa Lu, Yuhui Zhu, Qifan Jiang, Shan Yin, Ruixue |
spellingShingle |
Wang, Kemin Kang, Liangfa Lu, Yuhui Zhu, Qifan Jiang, Shan Yin, Ruixue Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
author_facet |
Wang, Kemin Kang, Liangfa Lu, Yuhui Zhu, Qifan Jiang, Shan Yin, Ruixue |
author_sort |
Wang, Kemin |
title |
Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
title_short |
Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
title_full |
Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
title_fullStr |
Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
title_full_unstemmed |
Highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
title_sort |
highly porous tissue scaffolds based on cyclic acetals with tunable hydrophilicity and degradation behavior |
publisher |
Wiley |
publishDate |
2021 |
url |
http://dx.doi.org/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/pdf/10.1002/pat.5217 https://onlinelibrary.wiley.com/doi/full-xml/10.1002/pat.5217 |
genre |
Carbonic acid |
genre_facet |
Carbonic acid |
op_source |
Polymers for Advanced Technologies volume 32, issue 5, page 1997-2006 ISSN 1042-7147 1099-1581 |
op_rights |
http://onlinelibrary.wiley.com/termsAndConditions#vor |
op_doi |
https://doi.org/10.1002/pat.5217 |
container_title |
Polymers for Advanced Technologies |
container_volume |
32 |
container_issue |
5 |
container_start_page |
1997 |
op_container_end_page |
2006 |
_version_ |
1800749992520974336 |