Is the Basal Ice of a Temperate Glacier at the Pressure Melting Point?
Abstract Certain aspects of the flow of glaciers suggest that molecular adhesion contributes to basal friction of glaciers sliding at speeds below those of surging glaciers. Laboratory experiments indicate that this will only occur if some part of the ice-rock contact is “cold”, that is below the pr...
| Published in: | Journal of Glaciology |
|---|---|
| Main Author: | |
| Format: | Article in Journal/Newspaper |
| Language: | English |
| Published: |
Cambridge University Press (CUP)
1976
|
| Subjects: | |
| Online Access: | http://dx.doi.org/10.1017/s002214300003152x https://www.cambridge.org/core/services/aop-cambridge-core/content/view/S002214300003152X |
| Summary: | Abstract Certain aspects of the flow of glaciers suggest that molecular adhesion contributes to basal friction of glaciers sliding at speeds below those of surging glaciers. Laboratory experiments indicate that this will only occur if some part of the ice-rock contact is “cold”, that is below the pressure melting point (p.m.p.), a few tenths of a degree being sufficient. Field evidence is scanty, but suggests that such cold patches may exist at the base of a temperate glacier. Discussion of pressure-melting within the basal ice mass, as distinct from processes at the ice-rock contact, indicate that excess water is formed in zones of high-pressure ice up-stream of obstacles. If this water is squeezed out of the ice by the pressure, we have a simple heat pump that will tend to cool the basal ice. The ice will warm again as the result of thermal conduction and internal friction, but before reaching the p.m.p. it can produce "cold" patches of the ice-rock contact, roughly estimated to be from 0. 1 to 1.0 m in extent. Another factor that could cause intermittent cold patches at the ice-rock interface arises from changes of basal water pressures with time beneath a glacier. If a major part of the weight of a glacier is supported by a thin water film at a relatively low pressure and by a small proportion of water film in which pressures are high, then over a large area the water pressures must balance the weight of ice. If however the pressure in the low-pressure film rises, the smaller high-pressure areas of stress concentration will suffer a proportionately greater decrease of pressure to maintain the total balance between pressure and weight, If changes take place rapidly, in a matter of hours, then in areas of stress concentration of the order of a metre or more across, the water film will freeze to the bed as stresses are relieved. This could cause stick-slip motion in a temperate glacier. Pressure-temperature effects at the ice-rock interface can help to explain certain features of glacial erosion, such as ... |
|---|