Microstructural change in ice: II. Creep behavior under triaxial stress conditions

• Published in: Journal of Glaciology
• Main Authors: Meglis, I. L., Melanson, P. M., Jordaan, I.J.
• Format: Article in Journal/Newspaper
• Language: English
• Published: Cambridge University Press (CUP) 1999
• Subjects: Journal of Glaciology
• Online Access: http://dx.doi.org/10.1017/s0022143000001295; https://www.cambridge.org/core/services/aop-cambridge-core/content/view/S0022143000001295

Abstract This work investigates the deformation of ice under deviatoric stresses and confining pressures expected during ice–structure interaction. Granular ice was tested under a range of confining pressures (5–60 MPa) and deviatoric stresses (up to 25 MPa), with sample temperatures between –8° and –10°C. Samples were deformed to increasing end-levels of axial strain, and were thin-sectioned and photographed immediately following testing. At all confinement levels, the original texture of the sample is completely transformed within the first 10–15% strain, to a fine-grained matrix with a few larger, isolated grains. At low confinements, grain-size reduction is associated with extensive microcracking. At high confinements, few cracks are observed. Observations suggest that microcracking, melting and recrystallization are active at all levels of confinement, though the relative importance of each depends on the confinement, stress and accumulated strain. Deviatoric stress is a strong factor in controlling the creep, reflected in both the time required for the sample to reach accelerated creep and the tertiary creep rate itself. Two exceptions to this pattern were noted. First, some samples experienced strain localization and eventual rupture. These specimens tended to have higher creep rates even in the initial stages of strain. Second, prior damage resulted in rapid softening compared with the behavior of undamaged specimens. However, when strain rates are compared among all samples at a given level of cumulative axial strain, the creep behavior obeys a power law over the whole range of strain levels tested. Effective viscosity decreased from 10 7.8 to l0 6.4 MPa − n s within the first 10% strain, during which the most substantial microstructural changes occurred, and then stayed relatively stable. The stress exponent, n , remained within the range 4.0–4.6. The dominant deformation mechanism appears to depend strongly on confining pressure (cracking at low pressure and dynamic recrystallization at high ...